How do you install a Miele built-in dishwasher?

For these steps, you need a Torx screwdriver, flat-head screwdriver, jigsaw, spirit level, pencil, tape measure, and scissors.

• Step 1. Apply the moisture barrier tape
• Step 2. Slide the dishwasher into the niche
• Step 3. Level the dishwasher
• Step 4. Adjust the front panel
• Step 5. Attach the front panel
• Step 6. Adjust the springs
• Step 7. Secure the sides with screws
• Step 8. Connect the dishwasher

First, you apply the moisture barrier tape. This is included with the dishwasher. Measure how far the counter sticks out from your kitchen cabinet. Cut the sides of the moisture barrier tape to the right length. Clean the bottom of the counter and apply the tape.

Before you slide the dishwasher into the niche, you first rotate the legs inwards. That way, you prevent scratches on your kitchen floor. Lay out the hoses without any kinks or loops. You can then slide the dishwasher into place.

You can level the dishwasher by adjusting the legs. Tighten the rear legs with a Torx screwdriver and the front legs with a flat-head screwdriver. You can remove the slats below the control panel if necessary.

Measure the distance from the bottom of the dishwasher to the bottom of the kitchen counter. Bring out the front panel and mark this distance with a pencil. Next, you place the included instruction sheet on the front panel. Drill holes of about 10mm deep in the indicated locations. Use a 2mm drill for this.

Use screws to fix the parts in place with a Torx screwdriver. Open the dishwasher slightly and attach the front panel with a Torx screwdriver. Note: don't use a drill for this, you might damage the front panel and dishwasher.

There's a screw on the bottom of the dishwasher that you use to adjust the springs. Adjust them in such a way that the door doesn't fall down when you let go of it at a 45-degree angle.

Secure the sides of the dishwasher with screws. Use a Torx screwdriver for this. Check if you can easily open the door. Does the door hit the baseboard? Saw off part of the baseboard, so that the door can open and close properly.

This last step is where you connect the dishwasher. Plug the connector into the socket and connect the water hoses to the faucet. Check if everything is properly connected during the first rinse. You've now successfully built in your Miele dishwasher.